HV'Art Crystal Lacquer - ORIGINAL

HV’Art Lacquer is a Clear single-pack waterborne Lacquer suitable for coating a wide range of Interior Surfaces.It is formulated for ultimate transparency, good chemical resistance, excellent hardness, and resistance to thermoplasticity. The exceptional structure enables vertical hold far beyond domestic products, excellent for use in situ.HV’Art Lacquer is an inherently non-yellowing formulation, suitable for use over difficult substrates. GLOSS LEVELS: Ranging from a Deep Matt through to almost Wet-Look.Mineral 00, Stone 02, Parchment 04, Vellum 06, Boiserie 08, Honed 10, Lustre 20, Quartz 40, Gilt 60, Ceramic 90, COLORS: N/A Transparent. AREA OF USE: As a Protective coat over Decorative Glaze, as a clear finish on all Solid Timber items, Doors, furniture, turned parts, frames, skirting boards, wall panelling, and stairs. METHOD OF APPLICATION: Synthetic brush & fine-haired rollers THINNING: Typically add between 10-20% drinking water depending on the requirements of flow and build. Technical characteristics Solids content (%): 31 ± 2Specific gravity (kg/l): 1.030 ± 0.030 Viscosity (DIN 4 at 20°C): 150seconds VOC Content: 42 g/ltr General characteristics Drying time (60 g/m2 at 20°C): Dust free 20’ Touch dry 60’Sandable: 4 hours Stir the product well before application to disperse any possible sedimentation. This operation is essential to ensure even matting on the substrate Thanks to the contents of acrylic/polyurethane resins and to its properties of excellent pore marking, it is particularly suitable for two-coat systems for open pore wood. DRYING: Drying of waterborne products must take place at temperatures not below 15°C and at a relative humidity preferably not exceeding 85%. Out of these limits, there is a slowing down of the drying and/or formation of a less hard and resistant film. It is always advisable for drying to be forced, with air previously de-humidified and warm (20-30°C).